Answer: This error is displayed when the obstacle sensor detects an obstacle that can collide with the head. Check that the setting value of “MEDIA THICKNESS” or “HEAD GAP” is appropriate against the actual thickness of the media. In addition, check on the followings. ・Dust or garbage is not sticking to the surface of table […]
Answer: This error occurs when the table does not operate normally. 1. Make sure the table is moving up & down. 2. Check if there is strange noise around the table. 3. The weight of media must be 5kg or less (including jig) by specifications. Check that the weight of the media mounted on the […]
Answer: Please see followings. 1. After completing printing, you can set whether to return to Local mode or to remain in Remote mode. For how to set it, see “OPERATION MANUAL” -> “Chapter 3” -> “Various settings” -> “Setting the work change”. When [OFF] is set: Keeps Remote mode after printing. […]
Answer: Put in the value directly. * Recommended gap is 1.5mm (.015 inch). ・If the head gap is changed, table height is also changed. ・UJF-3042 is equipped with a function [GAP CHECK]. When ON is selected: If an obstacle is detected before or during drawing, the table automatically moves down away from the obstacle. * […]
Answer: It can be used by the following products: [For UJF-3042 / UJF-3042FX] Note that, when using thin substrates (such as paper or film), the marks of vacuum holes on the board surface may remain after printing. Be sure to perform a prior test on substrates before using it. [For UJF-3042HG] When you print on […]
Answer: The following data is the power consumption of UJF-3042 series: [For UJF-3042/UJF-3042FX] Operation… 350VA or lower Standby… 120VA or lower [For UJF-3042HG] Operation… 450VA or lower Standby… 125VA or lower
Answer: please see the followings [For UJF-3042 / UJF-3042FX] 50mm (1.97″) clearance is supported. [For UJF-3042HG] Up to 150mm (5.9”) is supported. * When printing on a molding object of 100mm or smaller, it is necessary to install the accompanying vacuum table and the table spacers.
Answer: Please see the following description. [For UJF-3042 / UJF-3042FX] Fix by using vacuum or the screw holes for holding tools. According to the situation or condition of media, secure the media with tape. If, within the adsorption area, there are suction holes not closed by the media, close such suction holes placing thin sheet […]
Answer: *The printing speed varies depending on the used colors of ink and the profile. *The following information is provided only for a guide and is not guaranteed. [UJF-3042 / UJF-3042FX] Print speed of 300x420mm (11.8×16.5) (maximum size) Mode Resolution Pass Printing time Standard (priority in speed) 720×600 dpi 8 pass 4 min High quality […]
Answer: The following ink sets are available for each model: 220ml ink cartridges or 600ml eco-cartridges. Ink colors are indicated as shown below. For UJF-3042 For UJF-3042, the LH-100 ink is available: For UJF-3042FX For UJF-3042FX, The LH-100 ink, LF-200 ink, LF-140 ink and IJ primer [PR-100] are available. For UJF-3042HG For UJF-3042HG, the LH-100 […]
