Answer: The following two filters are placed on the carriage. • LED UV unit filter (SPC-0657) … Protects the UV lamp unit from dust or dirt. • Mist adsorption filter (SPC-0656) … Adsorbs ink mist during printing to prevent the nozzle surface (ink discharging surface) from getting dirty with ink. If the filters get dirty, […]
Answer: This error is displayed if data other than command data is received. 1. Reprint with different color profiles. 2. Check if there are some damages on the USB cable. [For UJF-3042HG] Check that the accompanying ferrite core is attached to USB. If not, attach it. 3. Replace the USB cable to other one. ・Use […]
Answer: Please see the followings: 1. After completing printing, you can set whether to return to Local mode or to remain in Remote mode. For how to set it, see “OPERATION MANUAL” -> “Chapter 3” -> “Various settings” -> “Setting the work change”. When [OFF] is set: Keeps Remote mode after printing. […]
Answer: Recommended speed mode is as follows: 720 X 900dpi 12pass / 1,440 X 1,200dpi 16pass is recommended. [For LF-140 ink with UJF-3042FX / UJF-3042HG] When using light colors with LF-140 ink, 1,440 X 1,200dpi 16pass is recommended. * When using the IJ primer PR-100 with UJF-3042FX/UJF-3042HG, set the number of pass as 24 or […]
Answer: Put in the value directly. * Recommended gap is 1.5mm (.015 inch). ・If the head gap is changed, table height is also changed. ・UJF-3042 is equipped with a function [GAP CHECK]. When ON is selected: If an obstacle is detected before or during drawing, the table automatically moves down away from the obstacle. * […]
Answer: Please see followings. [For UJF-3042 / UJF-3042FX] Note that, when using thin substrates (such as paper or film), the marks of vacuum holes on the board surface may remain after printing. Be sure to perform a prior test on substrates before using it. [For UJF-3042HG] When you print on thin substrates (such as paper […]
Answer: The following data is the power consumption of UJF-3042 series: [For UJF-3042/UJF-3042FX] Operation… 350VA or lower Standby… 120VA or lower [For UJF-3042HG] Operation… 450VA or lower Standby… 125VA or lower
Answer: Please see followings. [For UJF-3042 / UJF-3042FX] 50mm (1.97″) clearance is supported. [For UJF-3042HG] Up to 150mm (5.9”) is supported. * When printing on a molding object of 100mm or smaller, it is necessary to install the accompanying vacuum table and the table spacers.
Answer: Please see followings. [For UJF-3042 / UJF-3042FX] Fix by using vacuum or the screw holes for holding tools. According to the situation or condition of media, secure the media with tape. If, within the adsorption area, there are suction holes not closed by the media, close such suction holes placing thin sheet from material […]
